Precautions for the operation of rubber (plastic) hydraulic type compacting machine:

1、Test the insulation effect of each line regularly, and always pay attention to the warning content on the machine's warning sign.
2、When the movable parts and the compacting chamber are blocked, do not reach inside with your hand or iron rod, but use plastic rod to handle it carefully.
3、Be careful to be scalded when touching the high temperature parts.
4, there is a leakage of powder or sealing ring squeak, the four screw caps evenly loosened and then screwed into some of the rotor gap in the refining chamber and then add some material oil or oil, and then idling for 3-5 minutes at the same time with a hammer in the spring side of the sealing ring gland periphery can be gently hit a few times, such as leakage of powder and then adjust the individual spring tightness, if the sealing ring gland and the sealing ring sink of the side plate is very high, the sealing ring and the sealing ring is very tight, and the sealing ring is very tight. If the sealing ring gland and the refining chamber side plate sink is very close, it means that the sealing ring inside has been worn out and needs to be replaced again.
5, every day before starting the machine to check the gear oil, oil, grease level and lubrication status, every day to strengthen the attention is the triple oil cup oil level shall not be less than half.
6、Machine failure to stop the machine action in a timely manner, unrelated personnel shall not do any unauthorized action.