1.Composition of the machine

Φ360×1120r three-roll calender=1; powder coating device=1;

2.Uses of the machineRUBBER MACHINE

It is mainly used for the calendering of ordinary rubber to produce a film of a certain specification, and then after cooling, powder coating and curling, the rubber material is put on hold for 24 hours, and the next step of production requirements is carried out.

3.Applicable standardRUBBER MACHINE

The design and production of this unit conform to the national standards.

4.ColorRUBBER MACHINE

Customize. But the purchased parts (such as motors, brakes, etc.) keep the original color, and the safety parts are red (or yellow).

5.Applicable conditionsRUBBER MACHINE

The unit is suitable for ambient temperature of 5-35°C, working relative humidity: ≤60%, altitude ≤1000m, well-ventilated, well-illuminated conditions, and the surrounding environment should not contain acidic, alkaline or other gases that are corrosive to insulation.

6.Power RequirementsRUBBER MACHINE

Power supply: 380V 50Hz three-phase AC power supply (according to customer demand)

Cooling water: tap water ≤ 26 ℃ or forced cooling equipment provided by the user, 0.2 ~ 0.4MPa.

Circulating water: industrial demineralized water, 0.2～0.5MPa.

Compressed air: 0.6 ~ 0.8 Mpa, the quality grade reaches grade 334 in GB/T12377-91 "Quality Grades of Compressed Air for General Use".